1.1KW snow blower

Our Products

Feature :

1.Impeller JQT series gas ring 1.1KW snow blower pump installed on the motor rotor directly and no touch compression completely.

2.As the bearing is installed in the compression chamber outside,It can ensure the machines Max. working possibility under the Max. different pressure.

Configuration:

Working principle:

Inlet 1 suck gas firstly,then it goes into side channel 2,the impeller will give gas a speed in the direction of rotation.The centrifugal force of the blade make the gas acceleration and pressure increased.Gas pressure to further increased because of revolving and gas kinetic energy increased.

At last,side channel is becoming n1.1KW snow blower at the exit,the gas is squeezed out pressure chamber and exit.

Detailed Photo:

Applications

JQT 1.1KW snow blower pump is widely used in a wide range of pressure there were large pumping speed of ejector gas containing dust and water vapor is not sensitive to the widely used in metallurgical, chemical, food, electronic coating, etc

Exhibition Show

In stock

Certification

Factory

Before You Start

1.Should take measures to minimize the loss of the pipeline in order to reduce the loss of pressure and flow.

2.Should use the occasion to correctly estimate the pressure and flow of the work place, in order to select the appropriate type of air pump and piping.

Precautions

Use Note power supply voltage is adapted.Boot and run for 10 minutes before using the gas source.

3.Normal working power floating shall not exceed ten percent of the rated voltage.

4.Pump should be placed above the horizontal ventilated and dry place.

5 non-hazardous liquids into the pump body.

6.The air pump not have a corrosive, explosive materials used near.Air pump using ambient temperature -10 ~ 40 altitude higher than 1000 m parameters will change.

7.Users should professionals device protection switch and ground.User maintenance, overhaul air pump should be cut off the power.

FAQ

welcome to contact me

i, High-pressure Roots Blower Low noise
1.1KW snow blower with adoption of helical tri-lobe roots rotors and the discharge port of special geometry, the airflow noise is much lower compared to typical straight-lobe roots blower. The noise level can be reduced by 8db in the band of low frequency; hence the noise in the surroundings of blower can be significantly improved.

JHJHBJH
ii, High adiabatic efficiency
High-pressure Roots Blower with design of helical tri-lobe roots rotors, 1.1KW snow blower the airflow pulsation is less and the air streamline would be more stable. Therefore the fluctuation in airflow is less and then the energy waste can be reduced. Additionally, the instantaneous backflow of discharge is lower by the design of special discharge port. Compared to straight-lobe roots blower, the adiabatic efficiency can be raised up to 20%.

HJJHBJH
iii, High-pressure Roots Blower Super Energy saving
Compared to the typical1.1KW snow blower under the same operation conditions of discharge pressure and airflow volume, the power consumption of helical tri-lobe roots blower will be lower by 20.